The secrete to Easy Frames are the small round, removable ‘Gel Mounts’ that have been specifically designed to instantly adhere both the photo and frame to the wall.
To hang an Easy Frame, simply position your photo on the back of the Easy Frame, apply the small Gel Mounts as directed, and then press the frame to the wall – easy as that!
Easy Frames are completely removable without damaging surfaces (REALLY!) and will not leave a residue. To remove an Easy Frame, re-position or replace the photo, simply twist the frame to release the suction. The Gel Mounts will remove cleanly, without damage, and will not leave a residue.
Easy Frames can be used unlimited times. All you need is 6 Gel Mounts each time a frame is reused. Each frame comes with sufficient Mounts to hang it two times, and additional Mounts can be purchased.
Easy Frames can displayed on most clean dry surfaces in seconds including painted and wallpapered walls. Some surfaces exposed to heat or moisture/condensation may effect adhesion. It is not recommended to display Easy Frames above or near heaters or fire places. Before displaying your Easy Frames it is important to first TEST the wall surface you intend to display your frames on. To do this simply pre-clean both the wall and the back of the Easy Frame using a damp soft cloth with hot water. Then hang one frame with photo as directed on the ‘Instruction Card’ provided with your frames. Leave this test frame up over night, in the morning if it is still in place and fixed tightly to the wall you are all good to go!
The surface MUST be completely clean and dry before displaying your Easy Frames. Mix half a cup of Methylated Spirits with 2 cups of warm water. Then use a clean soft cloth to wipe the area down (micro fiber cloths work best). Once clean, leave the wall to completely dry for half an hour, then you are ready to go! if you do not have Methylated Spirits then just clean hot water will do. Also give the back of each frame a good clean before displaying.